侧向风速作用下聚氨酯泡沫双火源火蔓延研究

为探究环境风作用下逆向双点火源聚氨酯泡沫火蔓延及融合行为，开展多组对照实验并从材料传热机理角度分析侧向风速对火蔓延行为中火羽流形态、质量损失和辐射热流场等特征参数的影响。结果表明:风速与上述参数之间存在非线性关系。环境风效应使火焰被拉长且敷贴于预热区表面，增大预热区面积和热反馈；侧向风速的增加对FPU板材质量损失的影响逐渐弱化，且板材的熔滴率与风速呈正相关；无论侧向风是否存在，两侧逆向火焰融合后均达到整个蔓延过程中的峰值温度；风速的存在限制了火焰温度与辐射热通量峰值，也缩短了温度和辐射峰值出现的时间。     

热处理时间对餐厨垃圾高温干式厌氧发酵的影响

餐厨垃圾中有机物大部分以大分子的形式存在,对其进行热处理,破坏大分子有机物的存在形式,将会影响其干式厌氧发酵的过程。实验对餐厨垃圾进行了热处理(100℃),处理后将其在含固率(TS)20%、接种率25%的条件下进行高温55℃厌氧发酵。实验结果表明,热处理后,餐厨垃圾的理化性质发生显著变化,累计产气量、TS和VS的去除率均增大。当热处理时间为15 min时,餐厨垃圾的SCOD值最高,为59.49 g/L,比未处理时提高了3.3倍。同样该条件下,累计产气量也最高,为2 782.8 m L,与未处理相比累积产气量提高58.30%,第二产气高峰比未处理提前3天。各发酵瓶发酵前后TS、VS去除率的变化趋势与累计产气量的变化基本一致,累计产气量越大,TS、VS的去除率越大。     

阴角邻面火灾作用下L型钢管混凝土柱耐火极限研究

运用有限元软件ABAQUS计算L形带肋钢管混凝土柱阴角相邻两面受火全过程下的耐火极限,分析了阴角邻面受火方式下构件内部温度场和应力场的变化规律,在此基础上分析荷载比、宽厚比、计算长度、加劲肋纵向间距、荷载偏心率、荷载角等参数对耐火极限的影响规律。数据表明:荷载比、计算长度对构件耐火极限影响较大,随着荷载比和计算长度的增大,耐火极限基本呈线性下降;加劲肋间距对构件耐火性能影响较小;由于L形柱的特殊形式,偏心荷载对耐火极限的影响规律较复杂,荷载作用点偏向低温区可以提高耐火极限。     

基于火探管式的锂离子电池灭火技术研究

为研究锂离子电池灭火方案,基于火探管灭火技术同时利用新型清洁灭火剂Novec 1230,组装成火探管灭火系统。在灭火测试平台上以功率为200 W的电热管作为外热源引发单电池或电池模组热失控,通过改变火探管的布置位置,记录相应的灭火行为以及灭火效率,并对实验结果进行了分析。研究结果表明,当火探管灭火系统直接布置在电池正上方时,在起火后的5.6s内控制火情;随着灭火剂用量增加可以显著降低体系温度,防止电池复燃以及连锁热失控现象发生;火探管有效覆盖区域外的失控电池作为热源将继续加热临近电池,引发连锁热失控,造成灭火系统失效;根据电池热失控后的燃烧行为以及传热行为,提出相应的火探管灭火系统复合方案。     

The effect of moisture content within multilayer protective clothing on protection from radiation and steam

The moisture from skin sweat and atmospheric water affects the thermal protective performance provided by multilayer protective clothing. Four levels of moisture content were selected to evaluate the impact of moisture on thermal protection under dry (thermal radiation) and wet (thermal radiation and low-pressure steam) heat exposure. Also, the role of moisture and its relationship with exposure time were analyzed based on skin heat flux and Henriques integral value. The addition of moisture to a fabric system was found to result in differences in second-degree and third-degree skin burn times. When moisture is added to a fabric system, it both acts as a thermal conductor to present a negative effect and provides a positive effect owing to thermal storage of water and evaporative heat loss. The positive or negative effects of moisture are mainly dependent on the thermal exposure time, the moisture content and the presence of hot steam.     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性，利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg，对其进行阶段划分:阶段1为30℃~Tc；阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化，进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压，煤表观活化能最大，平均耗氧速率最小；阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化，单轴应力为2.7 MPa时为临界轴压，煤表观活化能最大，平均耗氧速率最小；阶段1和2煤导热系数随温度升高均先减小后增大，并且煤导热系数随单轴应力增大呈三次函数变化。     

Benchmarking Optical/Thermal Satellite Imagery for Estimating Evapotranspiration and Soil Moisture in Decision Support Tools

Generally, one expects evapotranspiration (ET) maps derived from optical/thermal Landsat and MODIS satellite imagery to improve decision support tools and lead to superior decisions regarding water resources management. However, there is lack of supportive evidence to accept or reject this expectation. We “benchmark” three existing hydrologic decision support tools with the following benchmarks: annual ET for the ET Toolbox developed by the United States Bureau of Reclamation, predicted rainfall‐runoff hydrographs for the Gridded Surface/Subsurface Hydrologic Analysis model developed by the U.S. Army Corps of Engineers, and the average annual groundwater recharge for the Distributed Parameter Watershed Model used by Daniel B. Stephens & Associates. The conclusion of this benchmark study is that the use of NASA/USGS optical/thermal satellite imagery can considerably improve hydrologic decision support tools compared to their traditional implementations. The benefits of improved decision making, resulting from more accurate results of hydrologic support systems using optical/thermal satellite imagery, should substantially exceed the costs for acquiring such imagery and implementing the remote sensing algorithms. In fact, the value of reduced error in estimating average annual groundwater recharge in the San Gabriel Mountains, California alone, in terms of value of water, may be as large as $1 billion, more than sufficient to pay for one new Landsat satellite.     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.